Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 User Guide 137
7 Stored Programming
This chapter describes how to use the Stored Programming feature to simplify multiple
operations into a simple procedure. First, you register a series of operations in a job
number. Later, you can select the job number to execute the stored operations when
required. You can store operations (both on the touch screen and the control panel) up
to immediately before pressing the <Start> button on the control panel.
NOTE: You cannot store operations performed on the [Setup Menu] screen.
Using Stored Programming
Follow the steps below to select and execute a job number.
1. Press the <All Services> button
on the control panel.
2. Select [Stored Programming] on
the touch screen.
3. Select a job number to be
executed.
4. Change the settings as necessary.
5. Press the <Start> button on the control panel.
NOTE: On the [Stored Programming] screen, only job numbers that have been
programmed are active and selectable.
Stored Programming
You can store up to 58 consecutive operations in each job number, up to the total of 40
job numbers. To register the required operations in a job number, follow the steps
below.
NOTE: A job number remembers not only operations performed on the touch screen
but also the buttons pressed on the control panel.
NOTE: If, after a job has been stored in Stored Programming, you then change the
default settings in System Settings, or make changes to Job Flow Sheet, Job
Template, Address Book, Comment, etc., the operation registered for each job will
also change.
To Next Page
Loading...
Need help?
General
