Loading Documents to Scan Xerox
®
D70n Scanner
User Guide 8-3
Scanning from the Automatic Document Feeder (ADF)
Scanning Regular Documents
Make sure the paper guide switch is in the correct position for scanning regular documents, as
indicated in the following illustration.
When the paper guide switch is in the down position, the paper guides can be adjusted to a
maximum of 8.5 inches (216 mm) wide. If the paper guides are adjusted wider than the
maximum for regular paper, documents may skew excessively during scanning.
Preparing Documents for Scanning
• Fan the documents to make sure all pages in the stack are separated.
• Bend and then flatten the document stack to make sure the horizontal edges are aligned to
help prevent paper from skewing while being pulled through the scanner.
• Pinch the ends to align the leading edges slantwise to help prevent multiple pages from being
fed through at a single time.
Loading Documents
1. Make sure the paper guide switch is in the down position.
2. Adjust the paper guides to the width of the document you want to scan. Extend the input tray
and output tray to the length of the document.
To Next Page
Loading...
Need help?
General