Phaser® 5500 Laser Printer
Copyright © 2004 Xerox Corporation. All Rights Reserved.
3-40
UNIX (Linux)
This topic includes:
■ "Quick Install Steps" on page 3-40
■ "Additional Resources" on page 3-41
Your printer supports connection to a variety of UNIX platforms through the parallel and
network interface. The workstations currently supported by CentreWare for UNIX/Linux to a
network-connected printer are:
■ Sun Solaris
■ IBM AIX
■ Hewlett-Packard HP-UX
■ DEC UNIX
■ Linux (i386)
■ Linux (PPC)
■ SGI IRIX
The following procedures enable you to connect your printer using any of the supported
versions of UNIX or Linux listed above.
Quick Install Steps
From the Printer
1. Verify that both TCP/IP protocol and the proper connector are enabled.
2. At the printer’s front panel, select one of these IP address options:
■ Allow the printer to set up a DHCP address.
■ Enter the IP address manually.
3. Print the “Configuration Page” and keep it for reference. For information about printing
Configuration pages, go to Reference/Features/Front Panel on the User Documentation
CD-ROM.
To Next Page
Loading...
Need help?
General