Xerox Phaser 6120 Reference Guide

Configuring the Printer
153
Auto-Sense Default When Auto is selected as the Default Emulation
(see above), the printer samples the incoming print
job to try to determine the correct emulation to use
for the job. If the printer is unable to discern the
emulation of an incoming print job, the setting for
this parameter is used as the emulation.
Choices: PCL5, PostScript
Default: PCL5
Configuration Menu Equivalent:
MENU SYSTEM DEFAULT/
EMULATIONS/AUTO DEFAULT
Save Changes Saves and applies any changes made.
Discard Changes If you made changes to any of the parameter
settings but do not wish to apply the changes,
selecting this button restores the last submitted
parameter settings.
Set as Default button Saves the changes made to Custom values.
Restore Default button Restores the Custom values to the ones saved in
custom defaults.
Restore Factory button Changes all settings to the Factory values.
Item Description

Xerox Phaser 6120 Specifications

General

Color	Yes
Print technology	Laser
Time to first page (black, normal)	13 s
Time to first page (color, normal)	22 s
Print speed (black, normal quality, A4/US Letter)	20 ppm
Print speed (color, normal quality, A4/US Letter)	5 ppm
Internal memory	128 MB
Processor model	300 MHz, 32 bit RISC
Maximum print size	210 x 297 mm
Maximum ISO A-series paper size	A4
I/O ports	USB
Power requirements	200 – 240 VAC / 100 – 127 VAC 50/60 Hz
Networking features	Ethernet/Fast-Ethernet
Non-operating relative humidity (non-condensing)	10 - 85 %
Total input capacity	200 sheets
Maximum input capacity	500 sheets
Printer fonts	PostScript
Maximum duty cycle	35000 pages per month
Number of PostScript fonts	139
Power consumption (printing)	380 W
Storage temperature (T-T)	-20 - 40 °C
Operating temperature (T-T)	10 - 32 °C
Operating relative humidity (H-H)	10 - 80 %

Weight and Dimensions

Dimensions (WxDxH)	442 x 395 x 341 mm