Xerox Phaser 6120 Reference Guide

191
Using the Network Setup Menu Options
If the printer is connected to a network, the following settings should be
specified. For details about each setting, contact your network administrator.
" When manually setting the IP address, Subnet Mask, and Gateway
turn off DHCP first.
TCP/IP
Enable
DHCP/BOOTP
IP Address
Purpose Enables or disables TCP/IP.
If YES is selected, TCP/IP is enabled.
If NO is selected, TCP/IP is disabled.
Options YES
NO
Default YES
Purpose If there is a DHCP or BOOTP server on the network,
specifies whether the IP address and other network
information is automatically assigned by the DHCP or
BOOTP server.
Options ON
OFF
Default ON
Purpose Sets the IP address of this printer on the network.
Range 0–255 for each xxx triplet
Use the Up and Down keys to increase or decrease each
number; use the Left and Right keys to move between
triplets.
Default 192.168.001.002

Xerox Phaser 6120 Specifications

General

Color	Yes
Print technology	Laser
Time to first page (black, normal)	13 s
Time to first page (color, normal)	22 s
Print speed (black, normal quality, A4/US Letter)	20 ppm
Print speed (color, normal quality, A4/US Letter)	5 ppm
Internal memory	128 MB
Processor model	300 MHz, 32 bit RISC
Maximum print size	210 x 297 mm
Maximum ISO A-series paper size	A4
I/O ports	USB
Power requirements	200 – 240 VAC / 100 – 127 VAC 50/60 Hz
Networking features	Ethernet/Fast-Ethernet
Non-operating relative humidity (non-condensing)	10 - 85 %
Total input capacity	200 sheets
Maximum input capacity	500 sheets
Printer fonts	PostScript
Maximum duty cycle	35000 pages per month
Number of PostScript fonts	139
Power consumption (printing)	380 W
Storage temperature (T-T)	-20 - 40 °C
Operating temperature (T-T)	10 - 32 °C
Operating relative humidity (H-H)	10 - 80 %

Weight and Dimensions

Dimensions (WxDxH)	442 x 395 x 341 mm