34 Phaser 7700 Color Printer
Printer Management
SysStart Job execution
A startup file (SysStart) is automatically run when you turn on or reset the printer. The
Japanese, Chinese and Korean fonts are loaded from the Phaser hard drive when this file is
executed. To customize the startup, use UsrStart.
Note
If the SysStart file contains an error, the printer ignores the remainder of the file
and may not start up as expected.
Front panel intensity
To make the front panel text more readable, you can adjust the intensity of the front
panel’s back lighting:
1. On the front panel, with Menus highlighted, press the OK key.
2. Scroll to Printer Setup Menu by pressing the Up Arrow or Down Arrow key.
3. Press the OK key.
4. Scroll to Set Front Panel Intensity by pressing the Up Arrow or Down Arrow
key.
5. Press the OK key.
6. Scroll until the desired back light intensity is displayed. The intensity values range
from 0 (no back light) to 10 (brightest back light).
7. Press the OK key.
Front panel contrast
To make the front panel text more readable, you can adjust the contrast between the text
and the background:
1. On the front panel, with Menus highlighted, press the OK key.
2. Scroll to the Printer Setup Menu by pressing the Up Arrow or Down Arrow key.
3. Press the OK key.
4. Scroll to Set Front Panel Contrast by pressing the Up Arrow or Down Arrow
key.
5. Press the OK key.
6. Scroll the value until you achieve the desired contrast between the text and the
background. The values range from 1 to 10.
7. Press the OK key.
Intelligent Ready mode
Intelligent Ready mode is an automated system that monitors the printer’s usage and
warms up the printer when you are most likely to need it.
To Next Page
Loading...
Need help?
General