21
Mounting the Wheels
Mount the wheels on the wheel axle hex hubs using #309310 (SH M4x8) screws
and #309310 (ST 4x12) cone washers. Note the orientation of the cone washer
in the detail image.
Make sure the wheel screws are very tight, so the wheels do not loosen
during racing.
DETAIL
309310
SH M4x8
309310
ST 4x12
6-CELL BATTERY PACK (INLINE)
NOT INCLUDED
TIRES AND INSERTS
NOT INCLUDED
The XRAY T1FK'05 is a competition racecar, and therefore does not come
supplied with tires and inserts. Check with racers at tracks you attend to
determine the best tire/insert combinations.
To install rubber tires and inserts on the supplied wheels,
do the following:
1. Install a foam insert into each tire, making sure it is centered.
2. Slide the tire (with insert) onto the wheel.
3. Carefully glue the tires to the wheels with CA glue.
WARNING:
Follow the adhesive manufacturer's instructions for proper use and
safety. Wear proper eye and hand protection.
CA GLUE
Mounting the Battery Pack
This car is designed to use a 6-cell inline battery pack composed of sub-C cells.
Place the battery pack onto the right side of the chassis between the battery stops
as shown.
Use high-strength fibre tape to secure the battery pack to the chassis.
ACCESSORY ASSEMBLY
To Next Page
Loading...
Need help?
General
