Xtreme xr1245 User Manual

Operation
Operation Manual 58
Stopping Travel
1. Stop the forklift by applying the service brake pedal.
2. Slow the forklift until it comes to a complete stop.
3. Move the travel select lever to NEUTRAL (N).
4. Set the parking brake to ON (engaged).
NOTE: The fuel tank capacity is 48 gallons.
• Make sure the forklift is level to obtain an accurate fuel
level reading.
• Shut o the engine.
• Ground the fuel nozzle against the ller neck to avoid
sparks.
Warning
To prevent death, serious injury, or property
damage, apply service brakes until the forklift
comes to a complete stop, move travel select
lever to NEUTRAL (N), set the Parking Brake
switch to ON (engaged), lower and retract the
boom, and shut o the engine before exiting the forklift.
Warning
Make sure the forklift comes to a complete
stop before moving the travel select lever. A
sudden change in direction of travel, while
carrying a load, can reduce stability and/
or cause the load to shift or fall, which could
result in death, serious injury, or property damage.
Changing Travel Direction
3. Release the service brake pedal.
4. Slowly press the accelerator pedal to start travel.
Engine fuel is ammable and
can cause a re or explosion
resulting in death or serious
injury. DO NOT smoke while
refueling and keep sparks and
open ames away from the forklift.
Warning
Refueling
Shut Down Procedure
1. Park forklift on level ground, if possible.
2. Stop the forklift by applying the service brake pedal.
3. Place the travel select lever in NEUTRAL (N) and set the
parking brake to ON (engaged).
4. Lower the boom and rest carriage on ground.
5. Turn the ignition key to OFF and remove the key.
6. If the forklift is parked on an incline, block the wheels.
1. Stop the forklift by applying the service brake pedal.
2. Move the travel select lever to FORWARD or REVERSE.
Caution
DO NOT leave forklift unattended during manual
regeneration.
Manual Regeneration
The manual regeneration should be performed by qualied
personnel. This procedure requires the engine to run
continuously for 15 to 30 minutes. The forklift cannot be
operated during this procedure.
1. Stop the forklift and set the parking brake (Do not release
the parking brake until the regeneration is complete).
2. Verify the engine is at low idle.
3. Verify the fuel level is sucient for 30 minutes of operation.
4. Verify the accelerator pedal is not depressed.
5. Press the Manual Regeneration Button.
6. The engine speed will increase to 1000 RPM and the High
Exhaust System Temperature (HEST) indicator will be
displayed.
7. Do not press the accelerator pedal.
8. Allow the manual regeneration to complete without
interruption.
9. The engine speed will decrease to low idle and the High
Exhaust System Temperature (HEST) indicator will turn
o.
10. The manual regeneration is complete.
11. Turn the engine o and re-start to reset the Exhaust
Aftertreatment System.

Xtreme xr1245 Specifications

General

Brand	Xtreme
Model	xr1245
Category	Forklifts
Language	English