Yaesu FT-70DR Instruction Manual

• Step
Sets the channel step for receiving channels.
• ATT
By ticking the checkbox of this item, the receive sensitivity is lowered by about 10dB. This is useful when,
for example, an adjacent strong radio wave interferes with the reception.
• S Meter SQL
Congure the normal noise squelch setting, and also the S-meter squelch level setting.
• BELL
Outputs a ringing tone when receiving a signal that satises the conditions set from the squelch type.
Set the number of times the tone (bell) rings.
• Half DEV
Lowers the transmit deviation to approximately half.
• Clock Shift
When an internal spurious signal occurs due to the microcomputer clock, turn this setting on (tick the
checkbox). This may improve the situation.
Usually, this item is set to "OFF" (un-tick the checkbox).
• Comments
Comments may be added to the edited VFO channels. Up to 255 letters can be used. This function
is useful in organizing the VFO channels by, for example, applying a category name to each channel.
These comments are not transferred to the FT-70DR/DE.
26
ADMS
-
10 Instruction Manual

Yaesu FT-70DR Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Modes	FM, C4FM
Battery	7.4V 1800mAh Li-ion
Waterproof Rating	IP54
Receiver Type	Double-Conversion Superheterodyne
Weight	9.9 oz (with battery)
GPS	No