EasyManua.ls Logo

Yamaha F30 User Manual

Yamaha F30
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
Specifications and requirements
16
Gear ratio:
2.00 (26/13)
Trim and tilt system:
Hydro tilt (F30EHA, F40EHA)
Power trim and tilt (F30A, F30HA,
F40A, F40HA)
Propeller mark:
G
Fuel and oil:
Recommended fuel:
Regular unleaded gasoline
Min. pump octane number (PON):
86
Min. research octane number (RON):
90
Fuel tank capacity:
24 L (6.34 US gal, 5.28 Imp.gal),
25 L (6.61 US gal, 5.50 Imp.gal)
Recommended engine oil:
YAMALUBE 4M FC-W or 4-stroke
outboard motor oil
Recommended engine oil grade 1:
SAE 10W-30/10W-40/5W-30
API SE/SF/SG/SH/SJ/SL
Engine oil quantity (without oil filter re-
placement):
1.5 L (1.59 US qt, 1.32 Imp.qt)
Engine oil quantity (with oil filter replace-
ment):
1.7 L (1.80 US qt, 1.50 Imp.qt)
Lubrication system:
Wet sump
Recommended gear oil:
Yamalube Marine Gearcase Lube or
Hypoid gear oil
Recommended gear oil grade:
SAE 90 API GL-4
Gear oil quantity:
0.430 L (0.455 US qt, 0.378 Imp.qt)
EMU33556
Installation requirements
EMU33566
Boat horsepower rating
WARNING
EWM01561
Overpowering a boat can cause severe
instability.
Before installing the outboard motor(s), con-
firm that the total horsepower of your out-
board motor(s) does not exceed the boat’s
maximum horsepower rating. See the boat’s
capacity plate or contact the manufacturer.
EMU40491
Mounting outboard motor
WARNING
EWM02501
Improper mounting of the outboard mo-
tor could result in hazardous condi-
tions such as poor handling, loss of
control, or fire hazards.
Because the outboard motor is very
heavy, special equipment and training
is required to mount it safely.
Your dealer or other person experienced in
proper rigging should mount the outboard
motor using correct equipment and complete
rigging instructions. For further information,
see page 46.
EMU33582
Remote control requirements
WARNING
EWM01581
If the engine starts in gear, the boat can
move suddenly and unexpectedly, pos-
sibly causing a collision or throwing
passengers overboard.
If the engine ever starts in gear, the
start-in-gear protection device is not
6BG-9-3F-E0.book 16 ページ 2018年11月1日 木曜日 午後5時1分
©2020 Yamaha Motor Corporation

Table of Contents

Other manuals for Yamaha F30

Question and Answer IconNeed help?

Do you have a question about the Yamaha F30 and is the answer not in the manual?

Yamaha F30 Specifications

General IconGeneral
Engine Type4-Stroke, SOHC
Prop Shaft Horsepower30 hp
Full Throttle RPM Range5000-6000 rpm
Starting SystemElectric
Gear Ratio2.08:1
LubricationWet sump
Gear ShiftF-N-R
Displacement747 cc
Fuel Induction SystemEFI (Electronic Fuel Injection)
Ignition SystemTCI
Shaft Length15 in, 20 in
SteeringRemote
Bore x Stroke65.0 mm x 75.0 mm (2.6 x 3.0 in.)

Summary

Safety Information

Outboard Motor Safety Precautions

Covers propeller, rotating parts, hot parts, electric shock, trim/tilt, and engine shut-off cord safety.

Outboard Motor Components

Instruments and Operation

Initial Operation and Break-in Procedures

Guidance on first-time oil fill, engine break-in, and pre-operation checks.

Engine Operation and Control

Procedures for operating the engine, starting, warming up, shifting, and stopping.

Trim, Tilt, and Shallow Water Operation

Instructions on adjusting trim angles, tilting the motor, and shallow water operation.

Maintenance Procedures

Fluid Changes and Component Replacements

Instructions for oil filter, gear oil, anodes, and propeller replacement.

Trouble Recovery

General Troubleshooting Guide

Addresses common issues like starting problems, rough idling, and power loss.

System-Specific Troubleshooting

Troubleshooting for power trim/tilt, alert indicators, and starter system issues.

Emergency Operation Procedures

Covers impact damage, fuse replacement, manual tilting, and emergency engine starting.

Related product manuals