Yamaha F30 User Manual (English)

To Next Page

To Previous Page

Maintenance

sion from cavitation or ventilation, or other

damage.

 Check the propeller shaft for damage.

 Check the splines for wear or damage.

 Check for fish line tangled around the pro-

peller shaft.

 Check the propeller shaft oil seal for dam-

age.

EMU30663

Removing propeller

EMU29198

Spline models

1. Straighten the cotter pin and pull it out

using a pair of pliers.

2. Remove the propeller nut, washer, and

spacer (if equipped). WARNING! Do

not use your hand to hold the propel-

ler when loosening the propeller nut.

[EWM01891]

3. Remove the propeller, washer (if

equipped), and thrust washer.

EMU30673

Installing propeller

EMU46121

Spline models

NOTICE

ECM00502

Make sure to use a new cotter pin and

bend the ends over securely. Otherwise,

the propeller could come off during oper-

ation and be lost.

1. Apply Yamalube Marine Grease or a

corrosion resistant grease to the propel-

ler shaft.

2. Install the spacer (if equipped), thrust

washer, washer (if equipped), and pro-

peller on the propeller shaft. NOTICE:

Make sure to install the thrust washer

before installing the propeller. Other-

wise, the lower case and propeller

boss could be damaged.

[ECM01882]

3. Install the spacer (if equipped) and the

washer. Tighten the propeller nut to the

specified torque.

1. Cotter pin

2. Propeller nut

3. Washer

4. Spacer

5. Propeller

6. Thrust washer

6BG-9-3F-E0.book 92 ページ２０１８年１１月１日　木曜日　午後５時１分

Other manuals for Yamaha F30

Installation Manual224 pages

Need help?

Do you have a question about the Yamaha F30 and is the answer not in the manual?

Yamaha F30 Specifications

General

Engine Type	4-Stroke, SOHC
Prop Shaft Horsepower	30 hp
Full Throttle RPM Range	5000-6000 rpm
Starting System	Electric
Gear Ratio	2.08:1
Lubrication	Wet sump
Gear Shift	F-N-R
Displacement	747 cc
Fuel Induction System	EFI (Electronic Fuel Injection)
Ignition System	TCI
Shaft Length	15 in, 20 in
Steering	Remote
Bore x Stroke	65.0 mm x 75.0 mm (2.6 x 3.0 in.)