6-19
1
2
3
4
5
6
7
8
9
PERIODIC MAINTENANCE AND MINOR REPAIR
Brake fluid level, checking<IXE>
EAU32344
Checking the brake fluid level
1
ZAUM00**
1. Minimum level mark
Insufficient brake fluid may allow air to
enter the brake system, possibly caus-
ing it to become ineffective.
Before riding, check that the brake fluid
is above the minimum level mark and
replenish if necessary. A low brake fluid
level may indicate worn brake pads and/
or brake system leakage. If the brake
fluid level is low, be sure to check the
brake pads for wear and the brake sys-
tem for leakage.
Observe these precautions:
8 When checking the fluid level, make
sure that the top of the master cyl-
inder is level by turning the handle-
bars.
8 Use only the recommended quality
brake fluid, otherwise the rubber
seals may deteriorate, causing
leakage and poor braking perfor-
mance.
Recommended brake fluid:
DOT 4
8 Refill with the same type of brake
fluid. Mixing fluids may result in a
harmful chemical reaction and lead
to poor braking performance.
8 Be careful that water does not en-
ter the master cylinder when refill-
ing. Water will significantly lower the
boiling point of the fluid and may
result in vapor lock.
8 Brake fluid may deteriorate painted
surfaces or plastic parts. Always
clean up spilled fluid immediately.
8 As the brake pads wear, it is nor-
mal for the brake fluid level to
gradually go down. However, if the
brake fluid level goes down sud-
denly, have a Yamaha dealer check
the cause.
5YR-F8199-14_ch6.pmd 2007/05/24, 19:5819
To Next Page
Loading...
Need help?
General
