7 Electrical Installation
46 YASKAWA TOEPC7106171FD FP605 DRIVE INSTALLATION & PRIMARY OPERATION
8. Align the closed-loop crimp terminals with the bolt holes on main circuit terminal block.
Figure 7.16 Install the Electrical Wires
9. Tighten the bolts to the specified torque.
Figure 7.17 Tighten the Terminal Block Bolts
10. Put the terminal cover back in its initial position.
■ Wiring the Main Circuit Terminal Block Using Procedure D
Main Circuit Terminal Block Wiring Procedure
1. Remove the terminal cover.
2. Remove the screws on the terminal block cover and pull the terminal block cover away from the drive. Pull the
wiring cover away from the drive. Do not discard the wiring cover.
A - Terminal block cover B - Wiring cover
Figure 7.18 Remove the Wiring Cover
To Next Page
Loading...
Need help?
General