13 European Standards
YASKAWA TOEPC7106171FD FP605 DRIVE INSTALLATION & PRIMARY OPERATION 99
A - SW (ON) B - Screw (OFF)
Figure 13.11 EMC Filter Switch Location 5
If you lose an EMC filter switch screw, use Table 13.8 to find the correct replacement screw and install the new
screws with the correct tightening torque.
NOTICE
Only use the screws specified in this manual. If you use screws that are not approved, it can cause damage to the
drive.
Table 13.8 Screw Sizes and Tightening Torques
Model Screw Size
Tightening Torque
N∙m
2011 - 2059, 4005 - 4065 M4 × 20
1.0 - 1.3
2075 - 2114, 4077 - 4124 M4 × 30
1.0 - 1.3
2143, 2169, 4156 M5 × 25 2.0 - 2.5
■ Install the External EMC Noise Filter
Drive models 2xxxA and 4xxxA must meet conditions in this section to comply with IEC/EN 61800-3.
Connect an EMC noise filter that complies with European standards as specified by Yaskawa to the input side
(primary side). Refer to External EMC Noise Filter Selection on page 102 to select the correct EMC noise filter.
Use this procedure to install an EMC noise filter to make equipment and devices added to the drive comply with the
EMC Directive.
1. Install the drive and EMC noise filter on the same grounded metal plate.
2. Wire the drive and motor.
3. Ground the wire shielding on the drive side and motor side.
A - Drive
B - 10 m (32.8 ft) maximum
C - Motor
D - Metal conduit
E - Grounding wire
Figure 13.12 Wiring the Drive and Motor
To Next Page
Loading...
Need help?
General