Basic Call Features
71
To place a call using the headset:
Do one of the following:
- With the optional headset connected, press to activate the headset mode.
Press the line key to obtain a dial tone.
Enter the desired number using the keypad.
Press , , or the Send soft key.
- With the optional headset connected, press to activate the headset mode.
Enter the desired number using the keypad.
Press , , or the Send soft key.
Note
The SIP-T26P IP phone can handle multiple calls at a time. However, only one active call
(the call that has audio associated with it) can be in progress at any given time. The
SIP-T26P IP phone can handle a maximum of 6 calls at one time.
To place multiple calls:
You can have more than one call on your SIP-T26P IP phone. To place a new call during
an active call, do one of the following:
- Press the line key. The active call is placed on hold.
Enter the desired number using the keypad.
Press , , or the Send soft key.
- Press or the Hold soft key to place the original call on hold.
Press the NewCall soft key.
Enter the desired number using the keypad.
Press , , or the Send soft key.
You can press or to switch between the calls, and then press the Resume soft
key to retrieve the desired call.
Note
When you are not in another call, you can answer a call in one of three ways:
Using the handset
Using the speakerphone
To permanently activate the headset mode, refer to Headset Prior on page 48.
If multiple accounts are registered on the phone, you can first press the desired line key
in the idle screen or press the Line soft key in the dialing screen, and then you can use
the selected account to place a call.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
