MAINTENANCE INSTRUCTIONS
A 159 A 160 A 161
EXCHANGE OF COOLANT
Keep the following instruction:
- Open the heating system valve (A) (at
cab tractors only) and release the
radiator overpressure filler cap (B).
- Drain the coolant from engine block
(C). Draining valve is accessible after
removing of the right side shield.
- Drain the coolant from radiator (D).
Draining valve is accessible after re-
moving of the left side shield.
- Close both draining valves after
draining of coolant (let the heating sys-
tem valve (A) opened).
Fill the cooling system with antifreeze
mixture - antifreeze + demineralized wa-
ter in ratio 1:1,5. Start the engine and let
it run approximately 1 minute. Add the
coolant and close the radiator by over-
pressure filler cap. The right coolant le-
vel is approximately 55 mm from the up-
per edge of filler when the cold engine.
Exchange the coolant at least after every
two years if the antifreeze is used in
coolant.
PDF byl vytvořen zkušební verzí FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
Need help?
General