Outgoing Calls
Dialog 4224 Operator76
If you need to make an urgent call and all lines are busy you can
intrude and force release a line:
Ò < Speech Press to intrude.
Inform the parties on the line about the situation.
ÓÒ < Speech Press to force release.
The call is disconnected and the terminal is cleared.
Start dialing again, use either ‘Via any line’ or ‘Via a specific line’.
Via an ISDN line or via a direct line to
another exchange within the private
network
z Dial the code for the ISDN external line or for the direct line.
z Dial the external number.
The dialed number is shown temporarily, then the display shows
(example):
Ò < Clear Press to terminate the conversation.
The call is disconnected and the terminal is cleared.
Note: If all lines are busy
CONGEST. is shown.
C= 1 I= 0
TRK OUTGOING <-
010003012
15:25
To Next Page
Loading...
Need help?
General