ABB 2 Series User Manual

67Maintenance and troubleshooting
EN
9. Maintenance and troubleshooting
In this section the user will be istructed on maintenance and cleaning procedures.
Preliminary requirements
Owner
9.1 Maintenance schedule for the owner
Frequency Task Procedure
3 months
Do a check for damage:
- EV charge cables
- Connectors
Check for:
• Cracks or ruptures
• Visible internal wires of the cable
4 months Clean the EVSE
Cleaning agent with pH value between 6 and 8
Do not use abrasive tools.
Do not apply high-pressure water jets.
6 months
Do a check for damage:
- EVSE
Check for:
• Touchscreen cracks
• Touchscreen doesn’t work
• Cracks or ruptures on the external parts
• Signs of rust that cause ingress of water
NOTE
When the EVSE is put in a corrosion sensitive
environment, superficial rust is possible on
welding points. This rust is only visual. There is
no risk for the integrity of the EVSE.
1 year
Make sure that the manufacturer
does maintenance on the EVSE
Ask the manufacturer to do the task.
1 year Replace the air inlet filters Ask the manufacturer to do the task.
After the
first year,
then 2 years
Replace the air outlet filters Ask the manufacturer to do the task.
5 years
Replace the heater (this is
required only in countries where
the heater is actually used: the
heater is active only in cold and/or
in high humidity countries )
Contact the manufacturer.
Refer to section About this document

ABB 2 Series Specifications

General

Brand	ABB
Model	2 Series
Category	Industrial Equipment
Language	English