5Introduction and general information
EN
1. Introduction and general information
This chapter will give instruction on the correct use of this document.
Chapter recipients:
• Owner
• Qualified installer
• User
1.1 Disclaimer and warranty conditions
ABB E-mobility shall not be liable for any damages, losses, costs or expenses resulting from the improper
handling of the EVSE, in particular resulting from non compliance with the instructions of this document and
other applicable regulations and standards (e.g. installation, transport, occupational health and other safety
standards).
The warranty Terms and Conditions are considered to be valid if all indications in this manual are adhered to.
ATTENTION
If the equipment is used in a manner not specified in this manual (any condition deviating from
those described herein must be expressly agreed with the manufacturer), the protections and
the certifications provided by the equipment may be impaired with the consequent loss of
warranty.
ATTENTION
Any modification, manipulation, or alteration not expressly agreed with the manufacturer,
concerning either hardware or software, shall result in the immediate cancellation of the
warranty.
1.2 Function and target of this document
The purpose of this document is to gives the information that are necessary to safely do these tasks:
• Install the EVSE
• Operate the EVSE
• Perform basic maintenance tasks
NOTE
This manual covers the EVSE only and NO other equipment (external protection devices,
electrical vehicles, etc) to which it is connected.
Some component’s information given in this manual is taken from the original supplier
documents. Please refer to the supplier websites for the complete and updated documentation.
To Next Page
Loading...
Need help?
General
