9Safety
EN
• Unprofessional or incorrect installation, installation not complying to standards, or installation
not following the installation instructions contained in the product specific manual.
• Improper operation (in breach of the technical requirements or specifications or manuals of the product),
negligence or repairs carried out by the Owner (or any third party not authorized by the manufacturer).
It is absolutely forbidden to modify the equipment.
•
Non-compliance with the applicable safety regulations or other legal standards by other parties than the
manufacturer.
• Insufficient ventilation of the equipment.
• Operation of the equipment outside of its design conditions.
• Damage or failure due to relocations or alterations of the equipment from the original installation location
or alteration of the overall normal condition of the system.
• Only make changes to the equipment if the manufacturer approves in writing of the changes.
• Damage or loss due to improper use of the equipment.
• EV low battery during use.
• Any check to make sure the battery is sufficiently recharged before using the EV.
• Deterioration resulting from transportation or particular environmental conditions;
• Performing maintenance incorrectly or not at all;
• The manufacturer is not responsible for disposal of the equipment, or part of it, which does not take place
on the basis of the regulations and laws in force in the country of installation.
2.1.1 Responsibilities and qualifications for the Users
Operators responsible of installation, operation, maintenance and service must:
• To know and implement the applicable laws and rules.
•
To identify the hazards and do a risk assessment prior to commercing work that result from the working
conditions on the site.
• To operate the equipment with the protective devices installed and make sure that all protective devices are
re-installed after any installation or maintenance operation.
• To make an emergency plan that instructs people what to do in the event of an emergency relating to the
equipment or to another site emergency.
• To make sure that all employees, the owner and third parties are qualified according to the applicable local
laws and/or rules to do the work.
• To make sure that there is sufficient space around the equipment to safely do maintenance and installation
activities.
•
To identify a site operator who is responsible for the safe operation of the equipment and for the coordination
of all work, if the owner does not do these tasks.
Moreover the qualified installer must:
• Fully knows the EVSE and its safe installation.
• Be qualified according to the applicable local rules to do the work.
• Obeys all local rules and the instructions in the installation procedures in this document.
2.2 Intended use
This equipment has the exclusive function of fast EV charging and it is intended to be used both in indoor and
outdoor environments.
DANGER
The manufacterer isn’t liable for any risk and damage related to its different use. Use the
equipment only for its intended use and do not change or alter the system under any
circumstances. If you use the EVSE in any other way than described in the related documents,
you can cause death, injury and damage.
Only use it in its original condition and with its proper aim.
NOTE
The equipment can be only connected to the electricity grid in countries for which it has been
certified.
The equipment may only be used in compliance with all its technical characteristics.
Only use the EVSE with accessories that the manufacturer provides and that obey the local rules.
NOTE
- DC fast charge: no additional cables are required.
- AC charge: the cable owned by the user must be used.
To Next Page
Loading...
Need help?
General
