28 ACS 400 User’s Manual
Copy Parameters from Panel to Drive (download)
Note! The drive must be stopped and in local control. Parameter 1602 PARAMETER LOCK must be
set to 1 (
OPEN).
Selecting Full Parameter Set
Initially only the basic parameters are visible. When full Menu is active, an asterisk appears on the
second row of the panel display in Menu. Activate this function again to resume the short Menu.
LED Indicators
Diagnostic displays
When the red LED of the ACS-PAN-A is on or blinking, a fault is active. The relevant fault message
flashes in the panel display.
When the green LED of the ACS-PAN-A is blinking, an alarm is active. The relevant alarm
message is shown in the panel display. Alarms 1-7 arise from button operation and the green LED
does not blink for them.
The alarm and fault messages disappear when MENU, ENTER or the arrow buttons on the control
panel are pressed. The message will reappear after a few seconds if the keypad is not touched and
alarm or fault is still active.
Red LED Green LED
OFF ON Power ON and drive is operating normally.
OFF BLINKS Alarm is active.
ON ON Fault is active. Drive can be reset from the control panel.
BLINKS ON Fault is active. Turn power off to reset the drive.
COPY TO DRIVE
0(18
LOC
ENTER
Press & hold
&23<,1*
)8//6+2570(18
)8//6+2570(18
0(18
0(18
*
Press & hold
ENTER
Visible if full menu is active.
http://nicontrols.com
To Next Page
Loading...
Need help?
General
