Introduction to this manual
20
Contents
The chapters of this manual are briefly described below.
Safety instructions give safety instructions for the installation, commissioning,
operation and maintenance of the drive.
Introduction to this manual lists the steps in checking the delivery and installing and
commissioning the drive and refers to chapters/sections in this manual and other
manuals for particular tasks.
Operation principle and hardware description describes the drive.
Mechanical installation instructs how to place and mount the drive.
Planning the electrical installation instructs on the motor and cable selection,
protections and cable routing.
Electrical installation shows how to wire the drive.
Installation of the AGPS board (Prevention of unexpected start-up, +Q950) contains
electrical installation instructions of the optional Prevention of unexpected start-up
function (+Q950) of the drive, and gives instructions for starting up, validating and
using the function.
Installation of the ASTO board (Safe torque off, +Q967) describes the electrical
installation of the optional Safe torque off function (+Q967).
Motor control and I/O board (RMIO) shows the external control connections to the
I/O board.
Installation checklist contains a list for checking the mechanical and electrical
installation of the drive.
Start-up and use describes the start-up procedure and use of the drive.
Maintenance contains preventive maintenance instructions.
Technical data contains the technical specifications of the drive, e.g. the ratings,
sizes and technical requirements, provisions for fulfilling the requirements for CE
and other markings and warranty policy.
Dimensional drawings contains the dimensional drawings of the drive.
Resistor braking describes how to select, protect and wire brake choppers and
resistors. The chapter also contains the technical data.
External +24 V DC power supply for the RMIO board via terminal X34 describes how
to connect an external +24 V DC power supply for the RMIO board using terminal
X34.
To Next Page
Loading...
Need help?
General