ABB PFEA 113 User Manual

Tension Electronics PFEA113, User Manual
Chapter 3 Commissioning
3-22 3BSE029382R0101 Rev C
3.12.5 Zero Set
Zero set is used to compensate for load cell zero signal and tare weight.
The zero setting range is ±2 x F
nom
(load cell nominal load).
Zero set menus are described in the following order for:
1. One roll
2. Two rolls
3. Segmented roll
NOTE
Zero set must be done with no web tension applied to the rolls.
Figure 3-12. Zero Set Menus
FastSetUp
WebTension
Presentation-
Menu
SetNominal-
Load
ServiceMenu
ZeroSet
SetWrapGain
> 5 s
AO 1 - AO 6
Miscellaneous
Menu
System-
Definition
ObjectType
DO 1 - DO 4
AI 1 - AI 2
DI
ZeroSet A, B AreYouSure ActionDone
(shown for 1 s.)
To SetWrapGain
1. Zero setting One Roll
3. Zero setting Segmented Roll
ZeroSet C, D AreYouSure ActionDone
(shown for 1 s.)
ZeroSet A, B AreYouSure ActionDone
(shown for 1 s.)
ZeroSet
ZeroSet A, B, C, D AreYouSure ActionDone
(shown for 1 s.)
To SetWrapGain
ZeroSet
To SetWrapGain
ZeroSet
2. Zero setting Two Rolls
ZeroSet A, B, C, D AreYouSure ActionDone
(shown for 1 s.)

ABB PFEA 113 Specifications

General

Brand	ABB
Model	PFEA 113
Category	Measuring Instruments
Language	English