System Utilities 2-27
Using the LAN MAC EEPROM Utility 0
Perform the following steps to write MAC (Media Access Control) information to
EEPROM:
Use
LAN.BAT
utility to write MAC values to EEPROM under DOS mode.
1. Get into a MS-DOS prompt and enter
ipconfig /all
to get ‘MAC address’ (MAC address
is the 16 digit number given as Physical Address ).
2. Run the
LAN.BAT
file.
3. Enter the ’MAC address’ to write MAC values. Flash process begins as shown as
follow:
Enter the MAC ID - Samle: 001636XXXXXX(_________): 00269E230844
Please waiting for EEPROM data filling ………
Please waiting for EEPROM data comparing ………
………
Current MAC ID of ESN EEPROM : 00269E230844
Compare ACER & OEM S/N of ESN EEPROM : PASS
4. Flash is completed when the message, Compare ACER & OEM S/N of ESN EEPROM:
PASS, is shown.
5. At the command prompt, run
VEEP_795.EXE
to write any changes in the data to the
EEPROM.
Figure 2-33. VEEPROM Command Prompt
6. Reboot the system when the process has completed.
To Next Page
Loading...
Need help?
General