Troubleshooting 4-13
Internal Microphone Failure 0
If internal Microphones fail, perform the following:
Figure 4-7. Microphone Failure
1. Check that the microphone is enabled. Navigate to
Start Control Panel Hardware
and Sound Sound
and select the Recording tab.
2. Right click on the Recording tab and select Show Disabled Devices (clear by
default). The microphone appears on the Recording tab.
3. Right click on the microphone and select
Enable
.
4. Select the microphone then click
Properties
. Select the
Levels
tab.
5. Increase the volume to the maximum setting and click
OK
.
6. Test the microphone hardware:
Select the microphone and click
Configure
.
Select
Set up microphone
.
Select the microphone type from the list and click
Next
.
Follow the on-screen prompts to complete the test.
7. If the Issue is still not resolved, refer to
Online Support Information
.
Start
Check M/B Mic.
cable
Re-assemble the
MIC cable to M/B
OK
NG
Check MIC wire
of LCD module
Swap MIC wire of
LCD module
OK
NG
Swap M/B