AGCO FENDT 1050 Vario S4 User Manual

3.3.3 Fault code 02.0.00 -
Fault code DIN brief description Cause Consequences Remedy
02 = Vario terminal 0, 1, 2 = fault weighting (0 = heavy, 1 = medium; 2 = light)
01... = sequential number The sorting of the error code is based on the serial number
02.0.02
A103 NT01/02 terminal
Invalid GD routing table EOL
programming
02.2.40
A103 NT01/02 terminal
Database almost full
02.1.41
A103 NT01/02 terminal
Database full Recording of field data no
longer possible
02.2.42
A102 VarioGuide GNSS ECU A103 NT01/02 terminal
Mismatch of software from terminal and GuideReceiver.
Not possible to activate VarioGuide
Adjust the software for the terminal or the software for the receiver
02.2.43
A103 NT01/02 terminal
User data partition is almost full
02.1.44
A103 NT01/02 terminal
User data partition is full VarioDoc recordings
terminated
02.2.45
A103 NT01/02 terminal
In the previous terminal 15 cycle, a
different VarioGuide system was detected
02.2.46
A103 NT01/02 terminal
The combination of terminal and VarioGuide is not permitted
Not possible to activate VarioGuide
02.2.48
A103 NT01/02 terminal
Terminal temperature too high or too low
Brightness (backlight) dimmed to a minimum value
02.0.80
A103 NT01/02 terminal
Faulty hardware (e.g. RAM or FLASH)
3. Faults and remedy
Maintenance 137
530.020.020.011 Rev.A

AGCO FENDT 1050 Vario S4 Specifications

General

Brand	AGCO
Model	FENDT 1050 Vario S4
Category	Tractor
Language	English