2.3 Engine
2.3.1 General
IMPORTANT:
The engine oil should also be changed prior to long periods of inactivity.
2.3.2 Check the engine oil level
Before starting the procedure
• Place the tractor level on a flat surface.
• Front axle suspension in center position.
• Start engine and allow it to idle.
Check the oil level
1.
Check the oil drain plug and oil filter for leaks.
2.
Turn off the engine
3.
After approx. 5 minutes, remove dipstick (A).
Fig. 3
4.
Wipe dipstick with a clean lint-free rag.
5.
Reinsert dipstick fully and twist into place.
6.
Remove the dipstick.
NOTE:
Fill to at least the MIN mark.
If the oil level is just above the MIN mark
then the oil must be topped up.
7.
If necessary, fill to the MAX mark.
NOTE:
Do not fill above the MAX mark. An
excessive quantity of oil could damage the
engine.
Difference in quantity of oil
The difference in the quantity of oil between
the MIN and MAX marks is approx. 4.0 l.
Fig. 4
2.3.3 Drain the engine oil
Preliminary conditions
• Engine oil temperature approx. 80°C.
• Place the tractor level on a flat surface.
• Front axle suspension in center position.
2. Service and maintenance
24 Maintenance
530.020.020.011 Rev.A
To Next Page
Loading...
Need help?
General