72
Setting Up the System
Selecting the Setting used at Power-On
5.5 Selecting the Setting used at Power-On
This parameter selects the instrument setting that is used at power-
on.
1. Press SYST repeatedly until P ON SET is shown at the bottom
of the display.
2. Use Modify keys to select the setting.
LAST is the setting that was in use when the instrument was
switched off.
DEFAULT is the default setting.
a number is the number of the setting location where the user has
saved a setting.
Resetting the Power-On Setting
To reset P ON SET press and hold SYST until the value resets (this
takes approximately two seconds).
P ON SET is reset to LAST.
5.6 Locking Out ENB/DIS
This selects how the shutter enabling and disabling key operates
while the instrument is being operated over the GPIB.
1. Press SYST repeatedly until SHUTTER is shown at the bottom of
the display.
2. Use Modify keys to select the setting.
NORMAL means that the shutter can be enabled and disabled as
usual with E
NB/DIS.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
