82
Programming the Attenuator
GPIB Interface
• The SCPI Consortium. Standard Commands for Programmable
Instruments. Published periodically by various publishers. To
obtain a copy of this manual, contact your Agilent Technologies
representative.
The attenuator interfaces to the GPIB as defined by the IEEE
Standards 488.1 and 488.2. The table shows the interface functional
subset that the attenuator implements.
Table 7-1 GPIB Capabilities
Mnemonic Function
SH1 Complete source handshake capability
AH1 Complete acceptor handshake capability
T6 Basic talker; serial poll; unaddressed to talk if
addressed to listen
L4 Basic listener; unaddressed to listen if addressed
to talk; no listen only
SR1 Complete service request capability
RL1 Complete remote/local capability
PP0 No parallel poll capability
DC1 Device clear capability
DT0 No device trigger capability
C0 No controller capability
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
