Agilent Technologies Agilent 33500 Series User Manual

Remote Interface Configuration
Resetting the LAN
You can clear the Web Interface password, turn DHCP on, and restart the LAN at any time:
l Front panel:
The message "Performing LAN Reset" is displayed while the LAN is reset.
l SCPI: (No equivalent command)
DHCP On/Off
DHCP (Dynamic Host Configuration Protocol) can automatically assign a dynamic IP address to a LAN device. Typically
easiest way to configure instrument for LAN.
l This setting is non-volatile; it will not be changed by power cycling or *RST.
l Front Panel:
Finally, toggle the first softkey to DHCP to use DHCP to automatically assign an IP address.
l SCPI: SYSTem:COMMunicate:LAN:DHCP <state>
To manually set an IP address, Subnet Mask, or Default Gateway, turn DHCP off, then change IP setup as described
below.
IP Address
You can enter a static IP address for the instrument as a four-byte integer expressed in dot notation. Each byte is a dec-
imal value, with no leading zeros (for example, 169.254.2.20).
l If DHCP is on, it attempts to assign an IP address to the instrument. If it fails, AutoIP attempts to assign an IP
address to the instrument.
l Contact your LAN administrator to obtain an IP address.
l This setting is non-volatile; it will not be changed by power cycling or *RST.
120 Agilent 33500 Series Operating and Service Guide

Agilent Technologies Agilent 33500 Series Specifications

General

Brand	Agilent Technologies
Model	Agilent 33500 Series
Category	Inverter
Language	English