EasyManuals Logo
Home>Agilent Technologies>Inverter>Agilent 33500 Series

Agilent Technologies Agilent 33500 Series User Manual

Agilent Technologies Agilent 33500 Series
429 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #174 background imageLoading...
Page #174 background image
[SOURce[1|2]:]AM:SOURce
[SOURce[1|2]:]AM:SOURce {INTernal|EXTernal|CH1|CH2}
[SOURce[1|2]:]AM:SOURce?
[SOURce[1|2]:]BPSK:SOURce {INTernal|EXTernal}
[SOURce[1|2]:]BPSK:SOURce
[SOURce[1|2]:]FM:SOURce {INTernal|EXTernal|CH1|CH2}
[SOURce[1|2]:]FM:SOURce
[SOURce[1|2]:]FSKey:SOURce {INTernal|EXTernal}
[SOURce[1|2]:]FSKey:SOURce
[SOURce[1|2]:]PM:SOURce {INTernal|EXTernal|CH1|CH2}
[SOURce[1|2]:]PM:SOURce
[SOURce[1|2]:]PWM:SOURce {INTernal|EXTernal|CH1|CH2}
[SOURce[1|2]:]PWM:SOURce?
Select the source of the modulating signal.
Parameter Typical Return
{INTernal|EXTernal|CH1|CH2}, default INTernal. BPSK and FSKey can-
not accept CH1 or CH2
INT, EXT, CH1, or CH2
Select external modulation source:
AM:SOUR EXT (could also substitute FM, BPSK, FSK, PM, or PWM for AM)
Remarks
l If you select EXTernal, the carrier waveform is modulated with an external waveform. Specifically:
l AM:The modulation depth is controlled by the ±5 V signal level on the rear-panel Modulation In connector.
For example, if modulation depth (AM[:DEPTh]) is 100%, then when the modulating signal is at +5 V, the out-
put will be at the maximum amplitude. Similarly, a -5 V modulating signal produces output at minimum ampli-
tude.
l FM:If you select the External modulating source, the deviation is controlled by the ±5 V signal level on the
rear-panel Modulation In connector.For example, if the frequency deviation is 100 kHz, then a +5 V signal
level corresponds to a 100 kHz increase in frequency.Lower external signal levels produce less deviation and
negative signal levels reduce the frequency below the carrier frequency.
l PM:With the External modulating source, deviation is controlled by the ±5 V signal level on the rear-panel
Modulation In connector. For example, if you have set the frequency deviation to 180 degrees, then a +5 V
signal level corresponds to a +180 degree phase deviation. Lower external signal levels produce less deviation,
and negative signal levels produce negative deviation.
Agilent 33500 Series Operating and Service Guide 173

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies Agilent 33500 Series and is the answer not in the manual?

Agilent Technologies Agilent 33500 Series Specifications

General IconGeneral
BrandAgilent Technologies
ModelAgilent 33500 Series
CategoryInverter
LanguageEnglish

Related product manuals