Agilent Technologies Agilent 33500 Series User Manual

Create a List of Frequencies
Create a List of Frequencies
Description
The LIST commands set the instruments's output frequency according to entries in a frequency list, which allows fast
changing to frequencies in a list of up to 128 frequencies. The frequencies to be used are entered using the
LIST:FREQuency command, or they may be read from a file using MMEMory:LOAD:LIST[1|2].
Examples
The following code demonstrates the LIST:FREQuency method.
FUNCtion SQU
FREQuency:MODE LIST
LIST:DWELl +5.0E-03
LIST:FREQuency +1.0E+03,+3.0E+03,+7.0E+03
VOLTage +1.0
OUTPut1 1
The results of this code are shown below.
332 Agilent 33500 Series Operating and Service Guide

Agilent Technologies Agilent 33500 Series Specifications

General

Vertical Resolution	14 bits
Output Impedance	50 Ω
Type	Function/Arbitrary Waveform Generator
Channels	1 or 2
Waveform Types	Sine, Square, Ramp, Pulse, Noise, Arbitrary
Interface	USB, LAN (LXI), GPIB (optional)
Frequency Range	1 µHz to 20 MHz (33521A/B), 1 µHz to 30 MHz (33522A/B)