Agilent Technologies Agilent 33500 Series User Manual

-24 dB Range Flatness Adjustment
-24 dB Range Flatness Adjustment
1. Connect a precision AC voltmeter to measure the output amplitude as shown below. Connect the BNC cable to the
Wide Band input of the Fluke 5790A.
2. Use the precision AC voltmeter to measure the output amplitude for each setup in the table below.
Setup Nominal Signal
Frequency Amplitude
38* 1 kHz 0.192 Vrms Flatness for -24 dB range
39* 100 kHz 0.192 Vrms Flatness for -24 dB range
40* 1 MHz 0.192 Vrms Flatness for -24 dB range
41* 5 MHz 0.192 Vrms Flatness for -24 dB range
42* 10 MHz 0.192 Vrms Flatness for -24 dB range
43* 20 MHz 0.192 Vrms Flatness for -24 dB range
44* 25 MHz 0.192 Vrms Flatness for -24 dB range
45* 30 MHz 0.192 Vrms Flatness for -24 dB range
* Constants are stored after completing this setup.
3. Using the numeric keypad or knob, adjust the displayed voltage at each setup to match the measured voltage.
Select ENTER VALUE.
4. After performing setup 45:
a. If your calibration procedures require you to verify the adjustment just made, exit the calibration menu and
perform -24 dB Range Flatness Verification.
b. If you are making all of the adjustments and then verifying the instrument’s performance, continue with the
next procedure in this section.
Agilent 33500 Series Operating and Service Guide 395

Agilent Technologies Agilent 33500 Series Specifications

General

Brand	Agilent Technologies
Model	Agilent 33500 Series
Category	Inverter
Language	English