EasyManuals Logo
Home>Agilent Technologies>Inverter>Agilent 33500 Series

Agilent Technologies Agilent 33500 Series User Manual

Agilent Technologies Agilent 33500 Series
429 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #408 background imageLoading...
Page #408 background image
Block Diagram
Block Diagram
The instrument has four main assemblies:
l Processor
l Main board
l Front panel
l Main power supply
A simplified block diagram appears at the bottom of this section.
The processor is a single board computer that contains the CPU, RAM, ROM, and circuits used to drive the GPIB, LAN,
and USB ports. The built in web interface is contained in the ROM. The processor circuitry is earth referenced.
When the power switch is pressed, the processor communicates with and loads the FPGA. This communication uses
three asynchronous serial data lines and one serial clock line. These four lines are isolated.
The FPGA stores all waveforms except arbitrary waveforms. Arbitrary waveforms are loaded into SDRAM on the main
board. All control of waveforms, triggers, sync signals, output path, attenuation, and offset is provided by the FPGA.
The main waveform for each channel (only one channel is shown in the block diagram) is loaded into the waveform
DAC and clocked by the timebase. The DAC output passes through an elliptical filter before the main attenuators. There
are three attenuators available in the path, -7.96 dB, -15.91 dB, and -23.87 dB.
The signal is applied to the output amplifier. The DC offset is summed at the output amplifier. A post amplifier -23.87 dB
attenuator is available for low level signals. The table below show the attenuators that create the output signal ampli-
tude.
Output Range
DC Offset < 320 mV
-7.96 dB -15.91 dB -23.87 dB -23.87 dB
(post)
10 Vpp - 3.6 Vpp Out Out Out Out
4 Vpp - 1.44 Vpp In Out Out Out
1.6 Vpp - 576 mVpp Out In Out Out
640 mVpp - 230 mVpp Out Out Out In
256 mVpp - 92 mVpp In Out Out In
102.4 mVpp - 36.86 mVpp Out In Out In
40.96 mVpp - 14.75 mVpp Out Out In In
16.38 mVpp - 5.90 mVpp In Out In In
6.55 mVpp - 2.36 mVpp Out In In In
2.62 mVpp - 1.00 mVpp In In In In
Output Range
DC Offset ≥ 320 mV
-7.96 dB -15.91 dB -23.87 dB -23.87 dB
(post)
9.36 Vpp - 3.6 Vpp Out Out Out Out
Agilent 33500 Series Operating and Service Guide 407

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies Agilent 33500 Series and is the answer not in the manual?

Agilent Technologies Agilent 33500 Series Specifications

General IconGeneral
BrandAgilent Technologies
ModelAgilent 33500 Series
CategoryInverter
LanguageEnglish

Related product manuals