Rockwell Automation Publication 8720MC-RM001K-EN-P - September 2018 85
Chapter 7
Configure Parameters
Parameters are used to define characteristics of the 8720MC-RPS unit. To
program the unit for a specific application, you display the appropriate
parameter and make adjustments as required. This chapter provides
information on parameter types, detailed descriptions of each parameter, and
describes how to access, display, and modify parameters.
About Parameters
Parameters break down into two types that can be used in the operation of the
8720MC-RPS unit.
Parameter Types
There are two types of parameters:
• User Parameters - These parameters can be adjusted or modified at any
time
• Factory Parameters - These parameters are initially set at the factory and
usually are not required to be adjusted or modified in the field
The factory parameters are protected by a password and the password must be
set to access these parameters. However, some parameters cannot be modified
during operation even though the password has been set.
Topic Page
About Parameters 85
User Parameters 88
Factory Parameters 89
Default Parameter Settings 97
ATTENTION: Only qualified electrical personnel familiar with the
construction and operation of this equipment and the hazards involved
should adjust and operate this equipment. Read and understand this manual
in its entirety before proceeding. Failure to observe this precaution could
result in destruction of the equipment, severe bodily injury or loss of life.
To Next Page
Loading...
Need help?
General
