Rockwell Automation Publication 750COM-UM009A-EN-P - May 2017 37
Configure the Interface Chapter 2
1. Depending on the type of server (BOOTP or DHCP) being used, set
0:300 - [Net Addr Sel] to either ‘2’ (BOOTP) or ‘3’ (DHCP)
respectively.
2. Make note of the Ethernet Address (MAC) of the interface hardware,
which is used in step
7.
There are two ways to find the media access control (MAC) address:
• Remove the drive cover and locate the hardware Ethernet Address
label on the main control board of the drive (Figure 7
).
Figure 7 - Location of the Interface Hardware Address Label
• Use the HIM to scroll to drive Port 0 and access the built-in
EtherNet/IP interface DIAGNOSTIC folder screen. Then scroll to
Diagnostic Items 43…48 (HW Addr 1…6) to view the hardware
Ethernet Address (MAC) of the interface. Finally, convert these
decimal values to hex values.
Value Setting
1 Parameters
2BOOTP
3DHCP (default)
ESC
ENTER
Stopped
0.00 Hz
AUTO
F
Edit Net Addr Sel
1<<3
With drive firmware 1.xxx or later
Ethernet
Address
(MAC)
Label
Location
Drive Control Pod
Ethernet Connectors
Front View - Main Control Board
To Next Page
Loading...
Need help?
General
