1 Publication 2711-UM014B-EN-P
Chapter
11
Installing the PV1400 Terminal
Chapter Objectives
This chapter describes how to mount the PV1400 terminal in a panel
or enclosure including:
• enclosures
• recommended tools
• mounting dimensions
• clearances
• cutout dimensions
• installing the PV1400 terminal in a panel
Enclosures
The PV1400 terminal must be mounted in an environment that
provides IEC-1131-2 Pollution degree 2 protection.
Mount the PV1400 terminal in a panel or enclosure to protect the
internal circuitry. The terminal meets NEMA Type 12/13 and 4X
(indoor use) ratings only when mounted in a panel or enclosure with
the equivalent rating.
Allow enough space within the enclosure for adequate ventilation.
Consider heat produced by other devices in the enclosure. The
ambient temperature around the terminals must be between 0° and
55° C (32° and 131° F).
Make provisions to access the back sides of the terminal. Access is
required for wiring, routine maintenance, adjusting brightness/
contrast, installing a memory card and troubleshooting.
Required Tools
In addition to the tools required to make the panel cutout, you need
the tools below.
For clip mounting:
• socket screwdriver (phillips head or slotted)
• 16-inch (406 am) extension rod (minimum)
• socket driver (in/lab torque wrench recommended)
For stud mounting:
• 7/32 and 3/8 inch socket
• 16-inch (406 mm) extension rod (minimum)
• socket driver (in/lb torque wrench recommended)
To Next Page
Loading...
Need help?
General
