28-EN
Setup
Setup Operation
To display the Setup Menu screen:
Your vehicle must be parked with the ignition key in the ACC or ON
position. To do this, follow the procedures below.
1 Bring your vehicle to a complete stop at a safe location.
Engage the parking brake.
2 Release the parking brake. (For safety, release the parking
brake while depressing the foot brake pedal).
3 Engage the parking brake again.
•
For automatic transmission vehicles, place the transmission lever in
the Park position.
•
“Sound Setup” (page 33) can be set even not engaging the
parking brake.
Now, the locking system for the Setup operation has been released.
Engaging the parking brake can reactivate the Setup Menu, as long as
the car’s ignition has not been turned o. It is not necessary to repeat
the above procedure (1 through 3).
Each time the ignition is turned OFF, perform the above procedure.
1
Touch the (HOME) button.
The HOME screen is displayed.
[Setup] button
2
Touch [Setup]button.
The Setup main screen is displayed.
Scroll Bar
*
Touch [ ] or [ ] to show further hierarchies.
3
Touch the required setting list, then touch the setting
item.
Setting items:
System: See “System Setup” (page 28).
Screen/Lighting: See “Screen//Lighting Setup” (page 32).
Sound: See “Sound Setup” (page 33).
Volume: See “Volume Setup” (page 38).
Bluetooth: See “Bluetooth Setup” (page 38).
Rear Camera: See “Rear Camera Setup” (page 39).
Lighting Link ON/OFF: See “Lighting Link” (page 40).
System Setup
[System] is selected on the Setup menu screen.
Setting item:
System
Setting contents:
Beep, Language, Time Adjust,SiriusXM, Product Information, Software
License, Connection Status, Steering Wheel Control, Reset
Beep Setup
You can change the volume of the sound heard when a button is
touched.
Setting item:
Beep
Setting contents:
O , On (Initial setting)
To Next Page
Loading...
Need help?
General
