HYC_50 – Operation and Installation Guide
Hardware
Version 1-2
All rights reserved. Reproduction of this document, in whole or in part, is only permitted with the permission of alpitronic GmbH.
8.4. Checking cleanliness and condensation
Check that the interior of the column is clean and shows no signs of condensation.
8.5. Checking the screws
Check the tightening torques on terminals and mechanical screw connections randomly or
completely.
Table 12: Torque of components
Information
If you have any uncertainties regarding tightening torques, please feel free
to contact our support team.
support@hypercharger.it or +39 0471 1961 333
8.6. Replacing the air filter inserts
Replace the air filter inserts regularly.
Figure 42: Air filter inlet
To Next Page
Loading...
Need help?
General
