Enova DGX Dante™ Audio Switching Boards
141
Hardware Reference Manual – Enova DGX 100 Series Digital Media Switchers
If the Dante Audio Switching Board defaults to “Embedded” rather than “Switched” audio:
Audio Switching Boards default to Switched audio but, if the system was upgraded from Enova DGX 8/16/32/64 to 100
Series and then power cycled prior to insertion of ASB boards, the system may not recognize the correct default state.
To resolve this issue, open the System Configuration interface and toggle the Audio Routing to its correct setting (see
page 173).
If you lose audio at destinations and in Dante Virtual Soundcard / Dante Via:
Check that all Dante hardware is powered and functioning normally.
Stop and re-start software.
IMPORTANT: If all Dante hardware capable of providing a Master Clock on the Dante network is removed from the network (even a
short interruption), software dependent on the Master Clock for syncing will remain out-of-sync until all of the software's processes
are stopped and re-started (where the software sends a fresh request to the Master Clock).
To Next Page
Loading...
Need help?
General
