Enova DGX Audio Switching Boards
147
Hardware Reference Manual – Enova DGX 100 Series Digital Media Switchers
Audio Switching Board Numbering Overlays
The Enova DGX 6400 can hold up to four Audio Switching Boards (two in the lower input-side expansion board slots and two in the
upper output-side expansion board slots). The Audio Switching Boards in the top of the enclosure work in conjunction with the
Input Boards; the Audio Switching Boards in the bottom of the enclosure work in conjunction with the Output Boards.
Overlays are provided to simplify Audio Switching Board connector wiring on the Enova DGX 100 Series enclosures that contain
ASB boards.
To apply ASB overlays to numbering plates:
1. Check the labels on the overlay to determine which system it applies to (see table below).
2. Peel the backing off the overlay and discard the backing.
3. Align the overlay carefully on the numbering plate and then press firmly on the overlay to set the adhesive on the numbering
plate.
4. Repeat Steps 1 through 3 as necessary for any remaining overlays.
Audio Switching Board Overlay Placement
FIG. 86 Audio Switching Board slot numbering overlays on Enova DGX 6400
Enclosure Audio Switching Board Numbering Overlay Placement
Enova DGX 800 Inputs 9-16, Outputs 9-16 Vertical numbering plate (rear center) - at bottom
Enova DGX 1600 Inputs 17-24, Outputs 17-24 Vertical numbering plate (rear center) - at bottom
Enova DGX 3200 Inputs 33-40, Outputs 33-40 Horizontal numbering plate (rear top) - at left / right ends
Enova DGX 6400 Inputs 65-80, Outputs 65-80 Vertical numbering plate (rear center) - at top / bottom
Audio Switching Board Numbering Overlays
To Next Page
Loading...
Need help?
General
