Enova DGX DXLink™ Twisted Pair Boards
88
Hardware Reference Manual – Enova DGX 100 Series Digital Media Switchers
Example of Typical Setup with DXLink Transmitter and Receiver
A typical system setup for a source and a destination is illustrated below and shows an Enova DGX 1600 with DXLink Boards used
in conjunction with DXLink Transmitters and Receivers for transport of HDMI signals.
This type of setup also supports DVI-D signals with the use of a cable adapter and analog video through a Multi-Format TX,
Wallplate TX, or Decor Wallplate TX.
The Transmitter receives an HDMI signal and an audio signal from a source device. The audio can be either digital audio embedded
with the HDMI signal, digital audio over S/PDIF, or analog stereo audio. Both the video and embedded audio are transmitted over
twisted pair cable to the RJ-45 connector on the DXLink Input Board. The signal is routed through the desired DXLink Output
connector to the DXLink Receiver, which in turn sends the HDMI signal with embedded audio on to a destination device. Audio
(whether embedded or not) received on the Transmitter can be output on the stereo audio port.
TIP: For systems with special requirements – Before installing in the final location, place the equipment close together, so a PC for
control and the destination monitor can be seen simultaneously if adjustments are necessary. Adjustments can be made using the
System Configuration interface (see page 163).
CAUTION: Be careful not to create a network (Ethernet) loop. To avoid doing so, see page 91.
FIG. 44
DXLink Boards used in conjunction with DXLink Transmitter and Receiver
AC
DC
FLT
AC
DC
FLT
DXLink Twisted Pair Input Board
DXLink Transmitter
Source Device
DXLink HDMI Receiver
DXLink Twisted Pair
Output Board
Destination Device
To Next Page
Loading...
Need help?
General
