EasyManuals Logo

APRILIA RS 660 User Manual

APRILIA RS 660
420 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #361 background imageLoading...
Page #361 background image
the brake pedal and it will make it arrive
at the end stop.
Close the bleed valve before arriving at
the end of the stroke with the pedal.
Repeat the operation until the are no
air bubbles in the fluid going into the
container.
NOTE
WHILE BLEEDING THE HYDRAULIC SYSTEM, FILL THE
RESERVOIR WITH THE NECESSARY QUANTITY OF
BRAKE FLUID. CHECK THAT, DURING THE OPERATION,
THERE IS ALWAYS BRAKE FLUID IN THE RESERVOIR.
Screw the bleeding valve and remove
the pipe.
Top-up the reservoir until the correct
brake fluid level is obtained.
Refit and block the front brake oil res-
ervoir cap.
Refit the rubber protection cover.
BLEEDING SYSTEM WITH DIAGNOSTIC INSTRUMENT
If the brake lever still feels "spongy" after completing all checks, it is necessary to bleed the
brakes using this type of procedure.
With the diagnostic tool properly connected, select the function "REAR BLEEDING" in the
section "SETTINGS".
The pump starts running.
While the pump is performing a rotation cycle, operate and release the rear brake pedal until
the message of diagnostic tool cycle completion is received.
This procedure allows the air to circulate and accumulate.
Once the procedure with diagnostic tool is finished, perform again the REGULAR PURGING
to remove the air from the system completely.
Front brake pump
RS 660 - Tuono 660 Braking system
BRAK SYS - 361

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the APRILIA RS 660 and is the answer not in the manual?

APRILIA RS 660 Specifications

General IconGeneral
Displacement659 cc
Bore x Stroke81 mm x 63.93 mm
Compression Ratio13.5:1
Maximum Power100 HP (73.5 kW) @ 10, 500 rpm
Maximum Torque67 Nm @ 8, 500 rpm
Transmission6-speed
FrameAluminum dual beam chassis
Front Tire120/70 ZR 17
Rear Tire180/55 ZR 17
Seat Height820 mm
Dry Weight169 kg
Wet Weight183 kg
Engine TypeParallel twin
Fuel SystemElectronic fuel injection with 48 mm throttle bodies
Front SuspensionKayaba 41 mm upside-down fork, adjustable rebound and preload
Rear SuspensionKayaba monoshock, adjustable rebound and preload
Front BrakeDual 320 mm discs, Brembo radial calipers
Rear Brake220 mm disc, Brembo caliper
ABSCornering ABS
Fuel Capacity15 liters
ElectronicsRide-by-wire, multiple riding modes, traction control

Related product manuals