APRILIA RS 660 User Manual

To carry out vertical adjustment of the light
beam:
(LOW BEAM HEADLIGHTS)
•
Operating from the rear side of the fair-
ing, under the internal bodywork, act
on the adjuster ("1" left side / "2" right
side). TIGHTEN (clockwise) to raise
the beam UNSCREW it (anticlockwise)
to lower the light beam.
•
These two adjuster screws may be
used to adjust the vertical alignment of
the low beam headlight beam.
NOTE
CHECK THAT THE VERTICAL ALIGNMENT OF THE BEAM
IS CORRECT.
(HIGH BEAM HEADLIGHT)
•
Operating from underneath the head-
lamp unit, turn the adjuster screw (3).
TIGHTEN (clockwise) to lower the light
beam; LOOSEN (anticlockwise) to
raise the beam.
•
This adjuster screw may be used to
adjust the vertical alignment of the high
beam headlight beam.
NOTE
CHECK THAT THE VERTICAL ALIGNMENT OF THE BEAM
IS CORRECT.
Anti-evaporation system
Removing system components
NOTE
IF THE FILTERING EFFECTIVENESS IS COMPROMISED, REPLACE THE COMPLETE CANISTER.
Maintenance RS 660 - Tuono 660
MAIN - 86

APRILIA RS 660 Specifications

General

Displacement	659 cc
Bore x Stroke	81 mm x 63.93 mm
Compression Ratio	13.5:1
Maximum Power	100 HP (73.5 kW) @ 10, 500 rpm
Maximum Torque	67 Nm @ 8, 500 rpm
Transmission	6-speed
Frame	Aluminum dual beam chassis
Front Tire	120/70 ZR 17
Rear Tire	180/55 ZR 17
Seat Height	820 mm
Dry Weight	169 kg
Wet Weight	183 kg
Engine Type	Parallel twin
Fuel System	Electronic fuel injection with 48 mm throttle bodies
Front Suspension	Kayaba 41 mm upside-down fork, adjustable rebound and preload
Rear Suspension	Kayaba monoshock, adjustable rebound and preload
Front Brake	Dual 320 mm discs, Brembo radial calipers
Rear Brake	220 mm disc, Brembo caliper
ABS	Cornering ABS
Fuel Capacity	15 liters
Electronics	Ride-by-wire, multiple riding modes, traction control