SL200 User Manual
Chapter 3 Router Setup
31
NAT-Traversal
: Enable the NAT-Traversal function.
Dead Peer Detection
: Enable Dead Peer Detection function
DPD Delay Time
: Interval Delay Time between DPD messages
DPD Retry Time
: Interval between DPD messages when no reply
from remote gateway.
DPD Max Failures
: The maximal time failures of DPD.
Anti-replay
: Enable the Anti-replay function.
Keep Alive
: Enable the Keep Alive function.
Counter Measure
: Enable the counter Measure function.
Max Failures
: The maximal time failures of Counter Measure.
Block Interval
: Block Interval between Counter measure.
3.6 LAN
3.6.1 LAN Settings
Congure the gateway address of the router. To dynamically assign
the IP address for clients’ PCs, enable the DHCP Server, set the
lease time, and then specify the address range. Valid IP addresses
consist of four numbers, which are separated by periods. The rst
three elds are the network portion ranging from 0 to 255, while the
last eld is the host portion ranging from 1 to 254.
To Next Page
Loading...
Need help?
General
