Chapter 3 Router Setup
SL200 User Manual
44
3.9.3 Dynamic Routing
Dynamic Routing can be used to cache routes learned by
routing protocols, thus allowing the automation of static routing
maintenance. The router, using the RIP (Routing Information
Protocol), determines the network packet’s route based on the
fewest number of hops between the source and the destination. In
this case, you can automatically adjust to physical changes in the
network layout.
Working Mode
: Select the router acts as router or gateway.
Listen Mode
: Enable this mode to allow RIP server to receive
routing information and update the routing information.
Supply Mode
: Enable this mode to allow RIP server to send out
routing information and update the routing information.
To Next Page
Loading...
Need help?
General
