Chapter 3 Router Setup
SL200 User Manual
34
Private IP:
This is the LAN client/host IP address to which the
Public Port number packet will be sent.
Private Port:
This is the port number (of the above Private IP host)
to wihich the Public Port number below will be changed when the
packet enters your LAN (to the LAN Server/Client IP)
Type:
Select the port number protocol type (TCP, UDP or both). If
you are not sure, leave it to be the default Both protocol.
Public Port:
Enter the service (service/Internet application) port
number that will be re-directed to the above Private IP address host
in your LAN.
Comment:
The description of this setting.
Enabled
: Enable Virtual Server.
3.7.2 Special Application
Some applications require multiple connections, such as Internet
gaming, video conferencing, Internet telephony and others. These
applications cannot work when Network Address Translation (NAT)
is enabled. If you need to run applications that require multiple
connections, specify the port associated with an application in the
“Trigger Port” out going port eld, select the protocol type as TCP
or UDP, then enter the public ports incoming port associated with
the trigger port to open them for inbound trafc.
To Next Page
Loading...
Need help?
General
