EasyManuals Logo
Home>AudioCodes>Gateway>Mediant Series

AudioCodes Mediant Series User Manual

AudioCodes Mediant Series
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
BroadCloud SIP Trunk
AudioCodes Mediant BRI/PRI Gateway 10 Document #: LTRT-12393
2.2 Mediant 500 PRI Media Gateway
Figure 2-8: Front Panel - Ports
Table 2-5: Front Panel
Item # Label Description
1 POWER / STATUS LEDs indicating the status of the power and reboot/initialization.
2 // Reset pinhole button to reset and optionally to restore to factory defaults. To restore to
factory defaults: Press and hold down the pinhole button for at least 12 seconds, but no
longer than 25 seconds, with a paper clip or any other similar pointed object.
3 CONSOLE RJ-45 port for RS-232 serial communication
4 LAN Up to four Gigabit Ethernet (10/100/1000Base-T) ports to connect to LAN (IP phones,
computers, or switches). These ports support half- and full-duplex modes, auto-
negotiation, and straight or crossover cable detection.
5 PRI Single E1/T1 port interface (RJ-48).
6 USB Two USB 2.0 ports. Do not use.
Figure 2-9: Rear Panel Earth and Power
Table 2-6: Rear Panel
Item # Label Description
1
Protective earthing screw.
2 I / 0 Power switch (O is off; I is on).
3 100-240V~50-60Hz 0.8A Max. Three-prong AC power supply entry.
2.2.1 Cabling
2.2.1.1 Grounding the Device
The device must be connected to earth (grounded) using an equipment-earthing conductor.

Other manuals for AudioCodes Mediant Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes Mediant Series and is the answer not in the manual?

AudioCodes Mediant Series Specifications

General IconGeneral
BrandAudioCodes
ModelMediant Series
CategoryGateway
LanguageEnglish

Related product manuals