4. Lamp & Lamp House
4. LAMP & LAMP HOUSE
About this chapter
This chapter enumerates a ll the supported xenon lamps for the D P 2K C-series projector and how to replace the xenon lam p in the
lamp house. Also included is the p rocedure to reset the lamp parameters, which is required after a xenon lamp replac ement, and
the procedure to realign the lamp in its reflector for optimal p e rformance.
WARNING: DO NOT P ERMIT UNAUTHO RIZED PERSONNEL TO PERFORM O R ATTEMPT ANY PHASE OF
XENON LAM P HA NDLING OR SERVICE. ONLY TRAINED AND QUALIFIED TECHNICAL SERVICE PERSONN EL
ARE ALLOWED TO HANDLE THE XEN ON LAMP.
CAUTION: Xenon comp act arc lamps are highly p ressu rized. W hen ignited, the norm al operating temperature
of the bulb increases the pressure to a level at which the bulb may explode if not handled in strict accord ance
to the manufacturer’s instructions. The bulb is stable at room temperature, but may still explode if dropped or
otherwise mishandled. W hen ever the lamp house, containing a xenon lamp , has to be dism antled or when ever
the protective container or cloth has to be removed from the xenon lamp , authorized protective clothing MU ST
be worn!
WARNING: Always wear fa ce pro tection (full face shield with neck protector) when handling xeno n lamps.
WARNING: Alw ays wear protective clothing (welder’s jacket) when handling x enon lamp s.
WARNING: Alwa ys wear clean leather gloves w ith w rist prote
ctors when handling xenon lamp s.
Overview
• Introduction
• Removal of the lamp hous e
• Removal of the xenon lamp
• Installation of the Xenon lamp
• Installation of the lamp house
• Resetting the lamp parameters
• Realignment of the lamp in its reflector
4.1 Introduction
Lamp & Lamp House
Normally the L amp Hou se of the DP2K C-series projector projector is delivered with a m ounted lamp. In case the xenon lamp is
delivered se parately the lamp has to be installed on site by a qualified service technician.
R5905050 DP2K C-SERIES 10/07/2012
21
To Next Page
Loading...
Need help?
General