R5905752 /16 DP2K C100
SYNC IN / OUT
Synchronization signal IN and OUT: Reserved for multiple-projector projection. Use a 50 Ohm coaxial
cable to connect the sync signal from projector to projector.
LAN 1 (2)
The ICMP-X can be connected to a LAN (local area network) using one of the Ethernet ports. These LAN
port are used for ‘content’ transfer.
NOTE: These ports are optionally used to connect to external content storage sources. Control of the
ICMP-X is done via the same IP address as the projector.
USB 2.0
The ICMP-X can be connected to a USB 2.0 Media to load content. The USB port can be used to load
content (DCP) or keys (KDM).
NOTE: It is recommended to use the USB 3.0 ports for faster ingest.
USB 3.0
The ICMP-X can be connected to a USB 3.0 Media to load content. The USB port can be used to load
content (DCP), or keys (KDM), or software update.
NOTE: These ports are recommended for fast ingest when connected to an appropriate USB 3.0 source.
USB
Universal Serial Bus (USB) is an industry standard developed in the mid-1990s that defines the
cables, connectors and communications protocols used in a bus for connection, communication,
and power supply between computers and electronic devices. USB 2.0 (also called "Hi-Speed"),
adding higher maximum signaling rate of 480 Mbit/s (effective throughput up to 35 MB/s or 280
Mbit/s), in addition to the "USB 1.x Full Speed" signaling rate of 12 Mbit/s.[16] USB 2.0 connectors
are usually colored black. USB 3.0 defines a new SuperSpeed mode with a signaling speed of 5
Gbit/s and a usable data rate of up to 4 Gbit/s (500 MB/s). A USB 3.0 port is usually colored blue,
and is backwards compatible with USB 2.0.
7.12 ICMP-X source input ports
Location of the source input ports
ICMP and ICMP-X equipped with two HDMI 2.0 (Reference 8, Image 7–20) as video source.
Image 7–20 ICMP-X (with HDMI 2.0).
ICMP with DisplayPorts (Reference 11, Image 7– 21) and HDMI 1.4 (Reference 10, Image 7– 21) are still
present on the field.
ICMP-X
To Next Page
Loading...
Need help?
General
